Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateTrusted Garage Door Installation for Washington Park Homeowners
A new garage door in Washington Park isn’t a quick swap – it’s a measured, ordered, carefully scheduled job, and it’s one where the wrong fit shows up every morning for the next fifteen years. We’re a single-trade garage door specialist, and installation is a big part of what we do. Our technicians have up to 12 years of experience, so they’ve seen how older doors here age, warp, and stop sealing right against a frame that’s settled a little differently than it did when it was new. We work on the brand you already have and the brand you’re considering. Installation work is measured and booked into the schedule: a free measure, a written price, then the work. For a door that’s failing right now, call (866) 369-6074. We answer 24/7.
What Our Garage Door Installation Service Includes
Every install starts the same way: we look at what’s there, measure the opening, and talk through what the door actually has to do for your house. From there, the work is a garage door job and nothing else – no framing, no general repairs, no passing you to a different trade.
New Door Installation
New door installation is a full replacement: the old door and its hardware come down, the opening is checked and corrected if needed, and a new door goes up with new track, rollers, springs, and hinges. You’ll want this when the door is beyond sensible repair – cracked panels, a bent or rusted bottom section, hardware that’s failed in several places at once. We measure the opening ourselves, order the door to that measurement, and set the new springs for the exact weight of the door. A door that’s been made to fit the opening is the difference between a door that runs quietly and one that grinds for years.

Single Car Door
A single car door is the narrower opening most Washington Park garages use, and it’s the size where fit matters most. Because there’s less room for error, the door has to match the opening precisely, and the torsion spring has to be matched to that specific door weight. We handle single doors as their own job, sized, ordered, and set up to run smoothly in a tight opening.

Double Car Door
A double car door is wider and heavier, so the spring setup, the track, and the opener all carry more load. That extra weight is why we look closely at the header and the track brackets before recommending a door – a wide door pulls harder on everything around it. We order double doors to the measured opening, size the springs for the real weight, and check that your opener’s rating matches the new door before it goes up. If it doesn’t, we’ll tell you plainly rather than leave you with an opener straining against a heavier door.

Custom Garage Door
Custom work is for openings that don’t fit standard sizes, or for looks that need a particular style – a specific window pattern, a finish that matches the house, a section layout that isn’t off the shelf. We measure, then order to those numbers. A custom door isn’t a reason to skip the basics: the springs, track, and opener still have to be set for the actual weight and swing of what’s being installed.
Steel Doors
Steel doors are the common choice for most homes here – durable, low maintenance, available in insulated and non-insulated versions. We install steel doors and pay attention to what matters in a place with temperature swings: insulation, the bottom seal, and how the door sits against the frame when closed. Panels take the weather first, so a steel door installed with a clean, well-sealed bottom edge does better over the years than one that’s just bolted into place.
Wood Doors
Wood doors give a look you can’t get from steel, and they need a little more care about moisture and finish. We install wood doors with the track and hardware set correctly, and we’ll point out the seal detail and finish protection that helps a wood door hold up through wet springs and dry summers. Weight varies more with wood than with steel, so spring matching matters even more – a wood door that’s set up wrong wears out its hardware and its opener quickly.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Brands We Service for Garage Door Installation
We work with Clopay and Amarr equipment and know how their doors go together, which panel profiles and insulation options are available, and where those doors tend to need attention over time. When you’ve picked a Clopay or Amarr door, we can order it, fit it to your opening, and match it with springs and hardware that suit the weight of that specific model. We’ll also talk through how a Clopay or Amarr model fits your opening and your budget before anything is ordered.
Wayne Dalton and Genie show up in a lot of Washington Park garages too. We service Wayne Dalton doors and Genie openers and know the quirks of both, including which Genie opener models pair with which door weights and where a Wayne Dalton door’s hardware tends to wear. Teaming those brands up correctly makes for a smooth, quiet door. Whether you have Genie, Clopay, Amarr, Wayne Dalton, or any other make, we can help. Or if you’d rather keep the door you’ve got and fix what’s failing, our Garage Door Repair Washington Park page covers that work.
Signs You Need Garage Door Installation Right Now
- Several panels are cracked or bent at once. A panel or two can be replaced, but once multiple sections are failing there’s not much left worth saving. A new door is usually the more sound choice at that point.
- The door has been hit and the tracks are visibly bent. A car-into-door hit can twist the frame and hardware, and even a bent track can put strain on every moving part. If the structure’s been pushed, a replacement is safer than chasing repairs.
- Repairs are piling up. When the springs have gone, the rollers squeal, and the opener is straining on a door that’s rusting, you’re spending money on a door that will keep asking for it. One replacement can be the cheaper route over a few years.
- The door doesn’t close flush and you can see daylight around the edges. Gaps mean weather and pests get in, and they usually point to a door that no longer matches the opening. That’s often a fitting problem a new door solves properly.
- The door is very old and parts are hard to find. Older doors can be a struggle to source hardware for. When parts aren’t available, a new door gets you back to something serviceable.
Our Garage Door Installation Process – Step by Step
- 1
Free measure and in-person look. We come out, measure the opening, check the header and the condition of the tracks, and look at your opener. We’ll also look at how the frame has held up, because an opening that’s shifted changes what door will fit.
- 2
Written price before anything is ordered. You get a written estimate with the door, hardware, and labor priced out, and the price is agreed before we start. Nothing gets ordered until you’ve seen the number and signed off on it.
- 3
Ordering and scheduling. Once the door’s approved, we order to spec and schedule the install. When your install day arrives, we work through the job in a logical order and keep you posted on where it’s at.
- 4
Old door out, opening checked, new door in. The old door and its hardware come down and the opening gets a final check before the new track, springs, and door go up. Springs are set for the correct door weight; that’s the step that decides whether a door runs right or fights you for years.
- 5
Full test and walkthrough. We run the door, check the balance and travel, adjust the opener if it’s being reused, and walk you through what’s been done before we leave. You’ll know how the door should sound and feel, so you can spot a problem early.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Installation Cost in Washington Park?
Garage door installation in Washington Park typically runs $825 – $2,595, depending on the door, the size, and what hardware comes with it. That range covers the door and the basic install work; standard doors land near the low end, and larger or custom doors land near the top.
A typical single car door with standard hardware runs in the lower part of that range, while a double car door or a custom door with specific finish and window options runs toward the higher end. Steel doors are usually on the lower side; wood and custom styles sit higher. Add an opener if yours isn’t going to be reused, and opener installation is a separate $295 – $650.
| Service | Typical Estimated Range |
|---|---|
| New Door Installation | $825 – $2,595 |
| Single Car Door | Lower end of the installation range |
| Double Car Door | Higher end of the installation range |
| Custom Garage Door | Higher end, priced per job |
| Opener Installation (if needed) | $295 – $650 |
What pushes the price up: a larger or heavier door, custom sizing, specialty finishes or windows, and an opener that needs replacing along with the door. What keeps it down: standard sizes, a steel door, and reusing a working opener that fits the new door’s weight.
The way to avoid overpaying is to get a written estimate that separates the door, the hardware, and the labor, and says what’s included in each. Our estimate is free, and the written price you sign is the price – not a rough idea that changes once the work starts. If you’re just comparing options or want a same-size replacement, we’re glad to measure and quote so you can see the numbers clearly. Call (866) 369-6074 for a free estimate.
Garage Door Installation Near Washington Park – Our Service Area
We cover Washington Park and the neighborhoods around it – Southmoor Park, Capitol Hill, Baker, Cherry Creek, University Park, Platt Park, Central Park, Virginia Village, Hilltop, Mayfair, and Sloan Lake. Most calls in these areas get a callback the same day, with installs measured and booked into the next opening. If a door is broken, not just old, fast dispatch from 7am to 7pm gets a technician out to look at it. If you’re nearby and comparing neighborhoods, our garage door installation page for Southmoor Park and the garage door installation page for Capitol Hill show what to expect. For a full new door anywhere in this area, the first step is a free measure.
Serving Washington Park, CO – Our Local Coverage Area
We serve Washington Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Garage Door Installation in Washington Park
Garage door installation is the process of removing an old door and fitting a new one, including the track, springs, rollers, and hinges – not just swapping panels. It’s different from a repair, which fixes a single failing part on a door that’s otherwise sound. If your door is structurally failing or you want a different look, it’s an install; if one part has failed, it’s a repair.
A standard single or double door installation typically takes most of a day, once the door is on hand. The job includes removing the old door, checking the opening, and setting up the new track and springs. Custom doors take longer to be made and delivered, so the overall timeline from measure to install is longer even though the install day itself looks similar.
Installation in Washington Park typically runs $825 – $2,595, depending on the door, its size, and the hardware. Standard steel doors land near the lower end; custom and larger double doors sit toward the top. The written estimate sets the final price, and it’s free – call (866) 369-6074 for an exact quote.
Yes, we service Clopay equipment and know how those doors and their hardware are put together. We can order a Clopay door, fit it to your measured opening, and match the springs to its weight. We also work with Genie, Amarr, Wayne Dalton, and other major brands.
Repairs can often be handled the same day, but a new install is measured, ordered, and scheduled rather than done on the spot. For a door that’s failed, fast dispatch from 7am to 7pm gets a technician out to look at it, Sunday through Friday. We answer 24/7, and a call outside dispatch hours is booked into the next opening.
Warranty terms depend on the door and the manufacturer’s coverage, so we go over what applies to your specific door in writing before anything is ordered. Ask us at the measure and we’ll spell out exactly what’s covered. You’ll have it in writing to keep.
Clear the garage floor and the space in front of the door, and move anything parked under or around the opening. Keep vehicles out of the way for the day so the old door can come down and the new one can go up safely. If you have pets, plan to keep them inside and away from the work area while we’re there.
Schedule Your Garage Door Installation Service in Washington Park Today
If your door is cracked, has been hit, or is just tired of being a door, a new install sorted correctly saves you years of small repairs. We’ll measure, quote in writing, and set up the install around your timeline. One call covers the full job – no runaround. Call (866) 369-6074 for a free, no-obligation estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. You can also read more about garage door installation and the brands we work on.
Written by the team at Garage Door Repair Washington Park.